似乎你已停用瀏覽器的JavaScript。除非你登入，否則此頁面上的某些功能將無法使用。

TPS24772RGET

Name: Texas Instruments TPS24772RGET
Brand: Texas Instruments
SKU: 595-TPS24772RGET
Price: 141.25 TWD
Availability: InStock

影像僅供參考
請參閱產品規格

Mouser 編號：

595-TPS24772RGET

製造商編號：

TPS24772RGET

製造商：

Texas Instruments

說明：

熱插拔電壓控制器 2.5 to 18V Hot Swap Controller A 595-TPS A 595-TPS24772RGER

規格書:

TPS24772RGET 規格書

ECAD模型:

下載免費的庫載入器，為ECAD工具轉換此文件。瞭解更多關於 ECAD 型號的資訊。

更多資訊

瞭解更多關於Texas Instruments TPS24772RGET的資訊

庫存量: 333

庫存：: 333 可立即送貨

發生意外錯誤了。請稍後再試。
工廠前置作業時間：: 9 週工廠預計生產時間數量大於所顯示的數量。

輸入數量：

最少： 1 多個： 1

單價:

NT$-.--

總價:

NT$-.--

估計關稅:

包裝:

完整捲（訂購多個250）

帶狀裁切

MouseReel™ (+NT$215.00)

Pricing (TWD)

數量	單價	總價
零卷 / MouseReel™ ^†
	NT$141.25	NT$141.25
	NT$106.83	NT$1,068.30
	NT$97.87	NT$2,446.75
	NT$88.55	NT$8,855.00
完整捲（訂購多個250）
	NT$83.53	NT$20,882.50
	NT$79.59	NT$39,795.00
	NT$77.08	NT$77,080.00
	NT$76.36	NT$190,900.00
	NT$76.00	NT$380,000.00

† NT$215.00 MouseReel™費用將加入您的購物車內並自動計算。所有MouseReel™訂單均不能取消和不能退換。 ↩

.hidden-for-nojs { display: none; } .pull-right-nojs { justify-content: flex-end; }

商品屬性	屬性值	選擇屬性
製造商:	Texas Instruments
產品類型:	熱插拔電壓控制器
RoHS:
產品:	Controllers & Switches
電流限制:	Programmable
電源電壓 - 最大值:	18 V
電源電壓 - 最小值:	2.5 V
通道數:	1 Channel
運作供電電流:	2.95 mA
最低工作溫度:	- 40 C
最高工作溫度:	+ 125 C
安裝風格:	SMD/SMT
封裝/外殼:	VQFN-24
封裝:	Reel
封裝:	Cut Tape
封裝:	MouseReel
停電檢測:	Yes
品牌:	Texas Instruments
輸入/電源電壓 - 最大值:	18 V
輸入/電源電壓 - 最小值:	2.5 V
濕度敏感:	Yes
產品類型:	Hot Swap Voltage Controllers
系列:	TPS24772
原廠包裝數量:	250
子類別:	PMIC - Power Management ICs
每件重量:	54.600 mg

找到產品:

若要顯示類似商品，請選取至少一個核選方塊

至少選中以上一個核取方塊以顯示在此類別中類似的產品。

所選屬性: 0

篩選文檔:

此功能需要啟用JavaScript。

合規守則

CNHTS:: 8542399000
CAHTS:: 8542390000
USHTS:: 8542390090
JPHTS:: 854239099
TARIC:: 8542399000
MXHTS:: 8542399901
ECCN:: EAR99

原產地分類

原產國:: 菲律賓
封裝原產國:: 無資料
擴散國:: 無資料

出貨時，國家可能會有所變更。

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up V_GS fault detection delay time, the transition V_DS fault detection delay time, and the continuous over-current V_DS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.

TPS2477x高效能熱插拔控制器

Texas Instruments TPS2477x High Performance Hot Swap Controllers are designed for 2.5V to 18V systems. With precise and highly programmable protection settings the TPS2477x aids the design of systems where isolating faults is critical. Programmable current limit, fast shut down, and fault timer protect the load and supply during fault conditions. The fast shut-down threshold can be tuned to ensure a fast response to real faults. Programmable Safe Operating Area (SOA) protection and the inrush timer keep the MOSFET safe under all conditions. After asserting power good, TPS2477x acts as a circuit breaker and runs the fault timer during over current events, but doesn't limit current. The device shuts down after the fault timer expires. Two independent timers (inrush/fault) allow the user to customize protection based on system requirements.
Learn More