TPS923650D2DSGR

Texas Instruments
595-TPS923650D2DSGR
TPS923650D2DSGR

製造商：

說明：
LED照明驅動器IC 65V 1A boost or buc k-boost LED driver w

壽命週期:
新產品:
該製造商的新產品。
規格書:
ECAD模型:
下載免費的庫載入器，為ECAD工具轉換此文件。瞭解更多關於 ECAD 型號的資訊。
更多資訊
瞭解更多關於Texas Instruments TPS923650D2DSGR的資訊

庫存量: 2,945

庫存：
2,945 可立即送貨
工廠前置作業時間：
12 週 工廠預計生產時間數量大於所顯示的數量。
最少： 1   多個： 1
單價:
NT$-.--
總價:
NT$-.--
估計關稅:

Pricing (TWD)

數量 單價
總價
NT$52.02 NT$52.02
NT$31.76 NT$317.60
NT$26.69 NT$667.25
NT$20.23 NT$2,023.00
NT$17.51 NT$4,377.50
NT$15.33 NT$7,665.00
NT$13.80 NT$13,800.00
完整捲（訂購多個3000）
NT$11.80 NT$35,400.00
NT$10.30 NT$61,800.00

商品屬性 屬性值 選擇屬性
Texas Instruments
產品類型: LED照明驅動器IC
RoHS:  
1 Output
Boost, Buck-Boost
1 A
WSON-8
63 V
4.5 V
1 MHz
5.5 V to 65 V
TPS923650
Cycle-by-cycle over-current protection, Fast load transient support, Integrated Switching FET, LED Open Detection, LED Short Detection, Thermal shutdown
Reel
Cut Tape
品牌: Texas Instruments
開發套件: TPS923650DRLREVM
調光: Analog
輸入電壓: 4.5 V to 63 V
安裝風格: SMD/SMT
通道數: 1 Channel
產品: LED Lighting Drivers
產品類型: LED Lighting Drivers
原廠包裝數量: 3000
子類別: Driver ICs
電源電流 - 最大值: 3.5 mA
找到產品:
若要顯示類似商品，請選取至少一個核選方塊
至少選中以上一個核取方塊以顯示在此類別中類似的產品。
所選屬性: 0

規格書

此功能需要啟用JavaScript。

CAHTS:
8542310000
USHTS:
8542310030
TARIC:
8542399000
ECCN:
EAR99

TPS92365x Boost/Buck-Boost LED Drivers

Texas Instruments TPS92365x Non-Synchronous Boost/Buck-Boost LED Drivers have a 4.5V to 65V wide input range. By integrating the low-side NMOS switch, the devices can drive LEDs and charge batteries with high power density and high efficiency. These devices are available with typical current limits of 1.5A (TPS922650), 3A (TPS922651, TPS922652, and TPS922653), and 6.5A (TPS922654 and TPS922655). The TPS92365x also supports common anode connection and single-layer PCB design. The switching frequency is configurable from 100kHz to 2.2MHz with an optional spread spectrum feature for better EMI performance.

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.

發生意外的錯誤。


有問題嗎？ 請瀏覽幫助中心。
有關特定訂單的問題，請登入您的帳戶。

如有其他問題，請致電800-346-6873或發送郵件至 help@mouser.com 與我們聯絡。