PM8805TR

STMicroelectronics
511-PM8805TR
PM8805TR

製造商：

說明：
熱插拔電壓控制器 IEEE 802.3bt PoE-PD interface with embedded dual active bridge
完成您的設計

規格書:
ECAD模型:
下載免費的庫載入器，為ECAD工具轉換此文件。瞭解更多關於 ECAD 型號的資訊。
更多資訊
瞭解更多關於STMicroelectronics PM8805TR的資訊

庫存量: 2,281

庫存：
2,281 可立即送貨
工廠前置作業時間：
25 週 工廠預計生產時間數量大於所顯示的數量。
此產品已報告長備貨期。
最少： 1   多個： 1
單價:
NT$-.--
總價:
NT$-.--
估計關稅:
包裝:
完整捲（訂購多個2500）

Pricing (TWD)

數量 單價
總價
零卷 / MouseReel™ †
NT$262.14 NT$262.14
NT$202.98 NT$2,029.80
NT$188.02 NT$4,700.50
NT$171.70 NT$17,170.00
NT$163.88 NT$40,970.00
NT$162.52 NT$81,260.00
NT$159.46 NT$159,460.00
完整捲（訂購多個2500）
NT$154.36 NT$385,900.00
5,000 報價
† NT$215.00 MouseReel™費用將加入您的購物車內並自動計算。所有MouseReel™訂單均不能取消和不能退換。 ↩

商品屬性 屬性值 選擇屬性
STMicroelectronics
產品類型: 熱插拔電壓控制器
RoHS:  
PoE / LAN Solutions
10 mA
57 V
9 V
2 Channel
600 uA
- 40 C
+ 85 C
SMD/SMT
VFQFPN-43
Reel
Cut Tape
MouseReel
No
品牌: STMicroelectronics
輸入/電源電壓 - 最大值: 57 V
輸入/電源電壓 - 最小值: 9 V
濕度敏感: Yes
產品類型: Hot Swap Voltage Controllers
系列: PM8805
原廠包裝數量: 2500
子類別: PMIC - Power Management ICs
每件重量: 121 mg
找到產品:
若要顯示類似商品，請選取至少一個核選方塊
至少選中以上一個核取方塊以顯示在此類別中類似的產品。
所選屬性: 0

CNHTS:
8542399000
USHTS:
8542390090
ECCN:
EAR99

PM8805 IEEE 802.3bt PoE-PD Interface

STMicroelectronics PM8805 IEEE 802.3bt PoE-PD Interface is a system-in-package for smart power supplies, and it is applicable for power levels up to 99.9W. The PM8805 embeds two active bridges and driving circuitry, a charge pump to drive the high-side MOSFETs, the hot swap MOSFET, and the interface compliant with IEEE 802.3bt. Performing the physical layer classification, the PM8805 indicates successful PSE-type identification. The device identifies which kind of PSE (standard or legacy) is connected and provides a successful IEEE802.3bt/at/af classification indication as a combination of the T0, T1, and T2 signals (open drain).

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.

發生意外的錯誤。


有問題嗎？ 請瀏覽幫助中心。
有關特定訂單的問題，請登入您的帳戶。

如有其他問題，請致電800-346-6873或發送郵件至 help@mouser.com 與我們聯絡。