Analog Devices Inc. ADL8122-EVAL1Z Evaluation Board
Analog Devices ADL8122-EVAL1Z Evaluation Board is a 4-layer printed circuit board (PCB) fabricated from 0.254mm (10 mil) thick, Rogers 4350B and Isola 370HR, copper clad, forming a nominal thickness of 1.63mm (64mils). The ADL8122-EVAL1Z was developed to extend frequency operation down to 10kHz and up to 10GHz. The RFIN and RFOUT ports on the ADL8122-EVAL1Z include subminiature A (SMA) and female coaxial connectors.
The ADI ADL8122-EVAL1Z Board is populated with components suitable for use over the complete operating temperature range, -55°C to +125°C.
Features
- 4-layer, Rogers 4350B and Isola 370HR evaluation board
- End launch, SMA RF connectors
- Through calibration path (depopulated connectors)
Applications
- Electronic test and measurement equipment
- Electronic warfare
- Wireless receivers
Required Equipment
- RF signal generator
- RF spectrum analyzer
- RF network analyzer
- 5V, 200mA power supply
Associated Amps
Analog Devices Inc. ADL8112 10MHz至26.5GHz放大器
內建旁路開關的低雜訊放大器 (LNA)，採用6 mm x 6 mm、28個端子的LGA封裝。
Analog Devices Inc. ADL8122 Wideband Low Noise Amplifier (LNA)
Operates from 10kHz to 10GHz with a typical gain and noise figure of 17dB and 2dB, respectively.
Eval Board
Analog Devices Inc. ADL8112-EVALZ Evaluation Board
Offers components ideal for use over the entire -40°C to +85°C operating range of the ADL8112.
Layout
Operating Block Diagram
Schematic & Assembly Drawing (J1 and J2 Not Installed)
發佈日期: 2025-03-14
| 更新日期: 2025-06-03