All Results (1,945)

Multiple Function Sensor Development Tools The MyoWare 2.0 Link Shield is designed to easily connect a MyoWare 2.0 Muscle Sensor to your Arduino microcontroller. The shield provides a 3.5mm TRS jack so that you can use a 3.5mm TRS-to-TRS cable to link the boards together. The MyoWare 2.0 Li

Cameras & Camera Modules The Arducam 5MP Plus OV5642 Mini provides an easy to use camera solution for those working with low-cost microcontrollers such as those used with Arduino and the RP2040 from Raspberry Pi. It's a general purpose 5MP camera module that's SPI enabled re

Multiprotocol Development Tools Don't be fooled by its miniature size; the SparkFun Pro Micro ESP32-C3 packs a punch. This micro marvel crams the powerful ESP32-C3 a single-core RISC-V powerhouse with 400KB of SRAM into a compact 1.3in. x 0.7in. board. Clocking in at 160MHz it's

Educational Kits If you do anything with electronics you re probably already using transistors but you re probably using them in large prepackaged clusters of just one type. The SparkFun Discrete Semiconductor Kit addresses your needs of only needing one or a

Multiple Function Sensor Development Tools The SparkFun micro:climate kit is a full weather station kit that is built on top of the weather:bit carrier board. Unlike previous weather kits we've carried the micro:climate kit includes our tried-and-true Weather Meters and Soil Moisture Sensor

Display Development Tools This compact OLED display packs a powerful punch transforming your creation with a crisp high-contrast 128x32 pixel canvas. Measuring just 0.91 inches this tiny display seamlessly integrates into your design while its low power draw ensures your

Test Plugs & Test Jacks This is a red insulated binding post. These binding posts do accept banana plugs and are a great way to connect single-wire leads. The colored cap screws up and down and is designed to clamp on the connecting wire.These binding posts are sold indiv

Daughter Cards & OEM Boards MOSFET Power Controller

SparkFun Accessories This 2x20 pin female header is meant to allow you to extend the reach of any board with the standard 2x20 GPIO pin footprint like the Raspberry Pi Google Coral and NVIDIA Jetson. You can also solder it to Pi HATs that do not have headers on the boa

Solenoids & Actuators Solenoids are a great way to induce linear motion for pushing pulling or controlling switches and levers. According to the datasheet this solenoid is rated for 36V but they work like a charm at 12V. We've been controlling them with the Arduino Power

DC Motors These micro gearmotors are incredibly tough and feature full metal gears. They have a gear ratio of 50:1 and operate up to 12 volts and have a stall torque of 20 oz-in. and a max speed of 460 RPM. Each micro gearmotor sports a 3mm D-shaft.Note: The m

Educational Robotic Kits Slip Ring 3 Wire (10A)