VORAGO Technologies RH-OBC-1 Radiation Hardened Board
VORAGO Technologies RH-OBC-1 Radiation Hardened (Rad-Hard) Board is a Pumpkin CubeSat kit bus compatible On Board Computer (OBC) / Command and Data Handling (C&DH) board. This board is designed with radiation-hardened components to mitigate the radiation effects, and the PCB's dimensions fit the CubeSat form factor design. The RH-OBC-1 board includes a VA10820 ARM Cortex-M0 MCU, two Infineon Technologies 256KB FRAMs, one Infineon 32MB serial NOR flash, one Intersil supervisor IC, and two LDO regulators.
Features
- All critical components are radiation-hardened
- CAN and UART-USB devices feature radiation mitigation protection circuits
- PCB dimensions are the CubeSat form factor
- 2.7oz. mass
- Pumpkin CubeSat kit bus compatible
- Board includes:
- VA10820 ARM Cortex-M0 MCU
- 2x Infineon 256KB FRAMs
- Infineon 32MB serial NOR flash
- ISL706A Intersil supervisor IC
- 2x ISL7502S Intersil LDO regulator
- RHD5950 Cobham Aeroflex 14-bit SAR ADC
- HI-3110 Holt CAN transceiver IC
- FT232RL FTDI USB to UART IC
- Standard CubeSat connectors:
- PC104 (CubeSat kit bus)
- Remove-Before-Flight switch
- EPS board pre-flight power connector
- JTAG connector
- CAN connector
- USB type B connector
Kit Contents
- RH-OBC-1 board programmed with demonstration firmware
- Quick start guide
- USB cable, type A male to type B male
- Schottky diodes, 0-ohm resistors, 5-pin header
- USB flash stick and firmware source code
Board Block Diagram
RH-OBC-1 Board Details
Additional Resource
發佈日期: 2018-09-21
| 更新日期: 2023-07-25